Technical Details for TGA DynTHERM

The DynTHERM TGA instruments can be equipped with different versions of the Magnetic Suspension Balance with the following specifications

Magnetic Suspension
Balance Type
Resolution Dynamic Weighing Range
(Sample Mass)
A 10 0.01 µg 200 mg
A 100 0.1 µg 500 mg
E 1 1 µg 10 g
E 10 10 µg 25 g

DynTHERM LP

The DynTHERM LP analyzers are applicable for thermogravimetric measurements between vacuum and atmospheric pressure.

The DynTHERM LP instruments are available with the following specifications:

DynTHERM LP - Model Balance Type Maximum Pressure Range Maximum Sample Temperature
ST A and E up to 1 bar 1100 °C
HT-II A and E up to 1 bar 1550 °C

DynTHERM MP

The DynTHERM MP analyzers are applicable for TG measurements between vacuum and 40 bar. As well as the LP series measurements with corrosive gases and vapor atmospheres can be carried out without the need of balance purge gas.


The DynTHERM MP instruments are available with the following specifications:

DynTHERM MP - Model Balance Type Maximum Pressure Range Maximum Sample Temperature
ST A and E up to 40 bar 1100 °C
HT A and E up to 30 bar 1200 °C
HT-II A and E up to 20 bar 1300 °C

DynTHERM HP

DynTHERM HP instruments are the ideal tool for thermogravimetric measurements at high pressures and as usual with the Rubotherm range of instruments corrosive atmospheres and vapor do not cause any problems.

The DynTHERM HP instruments are available with the following specifications:

DynTHERM HP - Model Balance Type Maximum Pressure Range Maximum Sample Temperature
II-LT E up to 350 bar 750 °C
LT E up to 150 bar 750 °C
ST E up to 100 bar 1000 °C

Contact Us

Details about the instruments are provided on the subsequent pages. The DynTHERM Series of instruments is customizable to a wide extend.

Contact us to discuss your research needs.